PCB 122A
http://www.intl-sensor.com Time:2008/6/10 13:12:17 Count : 5860 times
PERFORMANCE |
ENGLISH |
SI |
Sensitivity(± 20 %) |
1.1 pC/psi |
|
Measurement Range |
3 kpsi |
|
Maximum Pressure |
5 kpsi |
|
Resolution |
20 mpsi |
|
Resonant Frequency |
≥ 25 kHz |
|
Rise Time(Reflected) |
≤ 20 µ sec |
|
Non-Linearity |
≤ 1 % FS |
|
ENVIRONMENTAL |
|
|
Acceleration Sensitivity |
≤ 0.002 psi/g |
|
Temperature Range(Operating) |
-450 to +500 °F |
|
Temperature Coefficient of Sensitivity |
≤ 0.01 %/°F |
|
Maximum Flash Temperature |
4000 °F |
|
Maximum Shock |
10,000 g pk |
|
ELECTRICAL |
|
|
Output Polarity(Positive Pressure) |
Negative |
|
Capacitance |
18 pF |
|
Electrical Isolation |
≥ 108 ohm |
|
Insulation Resistance(at room temp) |
≥ 1012 ohm |
|
PHYSICAL |
|
|
Sensing Element |
Quartz |
|
Sensing Geometry |
Compression |
|
Housing Material |
17-4 Stainless Steel |
|
Diaphragm |
Invar |
|
Sealing |
Epoxy |
|
Electrical Connector |
10-32 Coaxial Jack |
|
Helium Flow Rate(at 1,500 psi) |
40 scf/hr |
|
Weight |
4.2 oz |
|
SUPPLIED ACCESSORIES: |
Model 070A08 Cable adaptor (micro 10-32 jack to BNC jack) (1) |
All specifications are at room temperature unless otherwise specified.
|
NOTES: |
[1] |
This pressure applies to sensor probe and adaptor assembly. |
[2] |
Maximum working pressure may be limited by helium source. |
[3] |
Source pressure should be at least twice the peak pressure but not more than 10 times the lowest pressure |
[4] |
Resolution dependent on range setting and cable length used in charge system. |
[5] |
With helium flow. |
[6] |
Zero-based, least-squares, straight line method. |
|
Keywords:
Rocket motor pressure probe, 3000 psi, 1 pC/psi, Helium bleed, conical end seal, 7/16 thd
Measurement Range: 3000 psi (20685 kPa)
Sensitivity: (±20%) 1.1 pC/psi (0.159 pC/kPa)
Temperature Range: (Operating) -450 to +500 °F (-268 to +260 °C)
Electrical Connector: 10-32 Coaxial Jack
Weight: 4.2 oz (120 gm)
INTL-SENSOR CopyRight
© Copyright By WWW.INTL-SENSOR.COM All Right
tel:86 010-67152280/67114885/67124125
E-mail:
pcb@intl-sensor.com